x20 turret contents

  • camera

  • adhesive mounting template

  • 3 × wall anchors with screws

  • weatherproofing kit

  • hex wrench

PoE advisory

Caution: If you are using PoE, ensure that your NVR has enough capacity, otherwise your cameras may randomly disconnect from your system.

Click here to download a PoE calculator in MS Excel.

Detach the mounting base

Loosen but do not remove the lock screw.

Remove the mounting base from the shell.

Install the mounting base

Use the adhesive mounting template to drill pilot holes.

Secure the mounting base in its location.

.

Remove the camera

Remove the camera ball through the bottom of the shell.

Open the utility port

Loosen the two captive screws and remove the utility slot cover.

Add an SD card

You can insert an SD card (up to 256GB) into the card slot, shown here. Use only a surveillance-rated SD card.

Reset button

This button is the reset button. If needed, while the camera is powered, press and hold this button for 30 seconds to restore it to factory defaults.

Replace the utility port cover.

Weatherproofing: Prepare the tail

Find the white washer in the weatherproofing kit.

Place it on the network connector of the camera's tail. The proper placement is shown here in yellow.

Weatherproofing: Insert the network cable

Slide a terminated category cable through the end cap and the casing.

Caution: Triple-check that your NVR has enough PoE capacity.

Weatherproofing: Connect the tail

Connect the terminated cable to the network connector of your camera's tail.

Weatherproofing: Secure the casing

Slide the weatherproof casing firmly onto the camera's network connector. Twist it to lock it in place.

Weatherproofing: Insert the sealing gasket

The sealing gasket has a slit in the side. Use this slit to place the gasket around the cable, then slide the gasket fully into the weatherproof casing.

Weatherproofing: Attach the end cap

Screw the end cap onto the casing until it is snug. The compresses the gasket around the cable, providing a weatherproof seal.

Connect the audio (optional)

To add external audio to the feed, connect your local microphone to "IN" and your amplifier to "OUT". The wires are labeled with a small tag.

Connect the alarm (optional)

If you wish to add an alarm or other such system to the camera, attach it to the Phoenix connector.

Connect the power (if needed)

If not using PoE, attach the power connector (we recommend using the EE-PS-12VDC-1A).

Pro Tip: Wrap any unused connectors to prevent short circuits.

Claim the camera in OvrC

If you have an OvrC Pro device, it automatically claims your camera. If not, claim it by manually entering its MAC address and service tag number. Once claimed, activate the camera in OvrC to help you adjust its aim.

Replace the camera

Return the camera ball to its position inside the shell.

Attach the camera

Opposite the lock screw, the shell has a small lip that secures it to the mounting base. Hook this lip around the base. Tighten the lock screw partway until you can swivel the shell, but cannot remove the shell from the base.

Aim the camera shell

Rotate the shell to aim the camera at the surveillance area.

Angle and level the camera

Angle the camera ball up or down to get the exact scene needed.

Tighten the lock screw

Secure the camera's position with the lock screw. Your installation is complete.