Factory Reset Procedure

Press and hold the and buttons until the LEDs blink red, then release the buttons.

LEDs 1 through 5 blink red and blue during the procedure. Once they stop, use the WAKE Amp mobile app to set up the amp again.

Note: -__.Factory resetting the amp also resets the paired device list, so the user must pair the WAKE Amp to the source again.

Firmware Recovery Mode

There are two ways to recover a WAKE Amp if it fails a firmware update. Once restored, try the firmware update again.

Hardware Method

  1. Remove power by unplugging the power supply from the AC power outlet.

  2. Press and hold the and buttons.

  3. Plug the power supply back in to the AC power outlet.

  4. Once LEDs turn on pink, release the buttons.

  5. All LEDs slowly blink pink. The unit is validating the stored factory default firmware file.

  6. All LEDs quickly blink pink. The unit is reprogramming the processor memory.

  7. LED 1 blinks pink. The unit is reprogramming the Bluetooth module.

  8. LED 1 blinks blue. The unit is ready to use.

Software Method

  1. Press and hold the and buttons.

  2. Once LEDs start blinking red, release the buttons.

  3. While the LEDs are still blinking red, press and hold the and buttons once more.

  4. Once the LEDs turn pink, release the buttons.

  5. All LEDs slowly blink pink. The unit is validating the stored factory default firmware file.

  6. All LEDs quickly blink pink. The unit is reprogramming the processor memory.

  7. LED 1 blinks pink. The unit is reprogramming the Bluetooth module.

  8. LED 1 blinks blue. The unit is ready to use.

Restarting the WAKE Amp

Press and hold the button. Continue holding while LEDs 1-5 start blinking blue, then release the button when they start blinking red.

Note: -__.If you continue to hold the button, the LEDs stop blinking. Releasing the button after this time has no effect and you’ll have to try again.